CATL's Tener Sodium block: 30+ MWh over four hours, 95% efficiency, deliveries in 2027
CATL has given more detail on its Tener Sodium battery energy storage system, the sodium-ion product launched at The Smarter E in Munich in June. pv magazine summarised the specifications on 14 November from an ATA Insights webinar held on 29 October, in which CATL product manager David Santiago presented datasheets for the battery and the company's own power converter. International deliveries are due to begin in summer 2027.
The system is built in pairs of cabinets, with two, four, six or eight available. The full eight-cabinet block stands in two back-to-back rows, measures 18.2 m by 7 m by 3.5 m, and weighs 44 to 45 tonnes per cabinet, about 4 MWh each. The specification gives a rated energy of more than 30 MWh and a rate of up to 0.25P, which is 7.5 MW over four hours. CATL plans an LFP version in the same cabinets at around 50 MWh per block, with the chemistry chosen at design stage, but is certifying the sodium version first.
The datasheet lists a nominal voltage of 1,166.88 V DC, 95% round-trip efficiency at 25°C and 0.25P, and 70% state of health after 20 years at one cycle a day. The liquid-cooled battery runs from -35°C to +55°C, is rated IP55 and works up to 4,000 m without derating. The webinar's degradation curves showed 71.3% capacity after 20 years at one cycle a day and 65.2% after 19 years at two, though Santiago called them older estimates and said newer data was better.
The in-house Terapower converter combines a DC/DC stage, which raises voltage at the low end of the battery's range, with the inverter. It accepts 600 V to 1,500 V DC, is rated at 265 kW with a 690 V AC output, and lists peak efficiency of at least 99.2%.
CATL compares the system with its own EnerX LFP product at 0.25P. It says the sodium cells generate 27.2% less heat per unit of energy at the beginning of life and 32.7% less at the end, so a 50 MWh station needs 490 kW of DC-side cooling instead of 720 kW. For a 500 MWh project it modelled 16 Tener Sodium blocks on 6,630 m² against 23 EnerX blocks on about 9,700 m², roughly 32% less land.

Why it matters
CATL's own case for sodium against its LFP product rests on the cold-weather range and the lower cooling load, and the datasheet now puts numbers on both. The degradation figures matter more for project finance, and CATL's own caveat that the published curves are out of date means buyers will want the newer data before signing long-term contracts.